Transmission Housing and Shift Mechanism Overview

Transmission Housing and Shift Mechanism Overview






1 Countersunk Bolt

• 33 Nm

2 Flange Shaft

• Removing and installing, refer to => [ Left Flange Shaft Seal ] Left Flange Shaft Seal

3 Securing Ring

• For the sealing cap - item 4 - => [ (Item 4) Sealing cap ]

• Installed (running change) approximately from transmission build date 21 01 8

4 Sealing cap

• Secured (running change) with securing ring approximately from transmission build date 21 01 8

5 Securing Ring

• For grooved ball bearing/input shaft

6 Back-Up Lamp Switch (F4)

• 20 Nm

7 Oil seal

• Replace

8 Bolt for Oil Drain Bore

• Internal hex bolt - 30 Nm

• Internal multi-point bolt - 45 Nm

• Observe different versions

9 Oil Seal

• Replace

10 Locking Bolt for Selector Shaft

• 30 Nm

11 Bolt

• 15 Nm plus an additional 90° (1/4 turn)

• Replace

• With permanent washer

• Allocation of bolts as replacement parts

12 Bolt -

• 15 Nm plus an additional 90° (1/4 turn)

• Replace

• Without washer

• Allocation of bolts as replacement parts

13 Selector Mechanism

• Disassembling and assembling, refer to => [ Transmission Side Shift Mechanism Overview ] Transmission Side Shift Mechanism Overview

• Removing with transmission installed:

- Remove battery and battery carrier

- Remove cables and transmission shift lever

- Remove locking bolt, remove selector mechanism

14 Bolt,

• 20 Nm

• Replace

15 O-ring

• Replace

16 Clutch Housing

• Servicing, refer to => [ Clutch Housing ] Clutch Housing

17 Transmission Housing

• Servicing, refer to => [ Transmission Housing ] Transmission Housing

Allocation of Bolts as Replacement Parts





A Bolt with permanent washer
B Bolt without washer
C Bolt with permanent washer

From transmission build date 1.21.08, the input shaft cap is secured with a circlip - A -.