Selector Lever Handle, With Stationary Selector Mechanism Cover

Selector Lever Handle, with Stationary Selector Mechanism Cover

Removing

- Move the selector lever into "D".

- Rotate the sleeve - 1 - to the right and push downward as far as stop.





- Carefully pull the button - 2 - out of the selector lever handle - 3 - until a cable tie can be slid between button and selector lever.

• Do not pull out the button any further, otherwise the selector lever handle will be damaged.

- Secure the lock button in pulled-out position using cable tie - arrow - as shown in illustration.

- Pull the handle for the selector lever upwards.

Installation

Install in reverse order, paying attention to the following:

- Move the selector lever into "D".

• To install new selector lever handle - 3 -, the button - 2 - must be pulled out all the way and secured with a cable tie - arrow - or using the assembly tool included with the new handle.





• If the button was not secured, do not pull it out from the handle using mechanical aids. Mount the compressed air gun to the bottom of the handle and then push the button out with compressed air.

- Install the selector lever handle - 3 - completely onto selector lever - the button - 2 - must face the driver. When doing this, handle must engage into ring groove of the selector lever.

- Remove cable tie - arrow - or assembly aid, thereby the button mechanism engages in the vertical groove of the selector lever. If necessary press button into selector lever handle.

- Pull the sleeve - 1 - upwards and lock this by turning it to the right.