Battery In Engine Compartment, Disconnecting and Connecting

Battery in Engine Compartment, Disconnecting and Connecting

Disconnecting






- Switch off ignition and remove ignition key.

- Remove battery cover - 1 - by pressing release button - arrow -.

- Loosen nut several turns and remove ground cable terminal clamp - arrow - from battery terminal.






Connecting

Vehicles without battery monitoring control module (J367)

- To connect, connect terminal clamp of ground wire by hand to battery negative terminal - and tighten nut.

Vehicles with battery monitoring control module






- Disconnect the electrical connector - 3 - on the battery monitoring control module - 1 -.

- Connect the ground wire terminal clamp 1 by hand to the battery negative terminal - - - and tighten the nut.

- Connect the electrical connector on the battery monitoring control module.

Continuation for all

When connecting the battery, perform the following steps:

• Follow the steps before starting the engine. Refer to owner's manual.

• Activate the power window regulator one-touch up/down function. Refer to owner's manual.

• Synchronizing the remote control. Refer to owner's manual.

• Check the DTC memories of all the control units and erase Undervoltage fault if necessary.

• After connecting the power supply, the ABS warning lamp may only go out after the vehicle has been driven a few yards.

Tightening Specifications