Seat Occupied Recognition Passenger Airbag Deactivation Seat Belt Latch

Seat Occupied Recognition Passenger Airbag Deactivation Seat Belt Latch

• The passenger occupant detection system seat belt latch is only installed on the passenger seat.

Removing






• Follow the safety precautions for pyrotechnic components.

• Replace the passenger occupant detection system seat belt latch each time the passenger belt tensioner deploys.

• Follow the disposal regulations for pyrotechnic components. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units, Storage, Transporting and Disposal ] Airbag, Belt Tensioner and Battery Cut-Out Units, Storage, Transporting and Disposal.

- Remove front seat:

• Manual seat, refer to => [ Front Manual Seat ] Front Manual Seat

• Power seat, refer to => [ Power Seat ] Power Seat

- Secure the seat on the (VAS 6136). Refer to => [ Front Seat, Installing on VAS 6136 ] Front Seat, Installing on VAS 6136.

- Disconnect both connectors (yellow and black) under seat not shown in illustration.

- Remove the bolt - 2 -.

- Remove seat belt latch - 1 -.

Installation


Follow the safety precautions for pyrotechnic components.

Installation is performed in reverse order of removal, noting the following.

- Replace the seat belt latch bolt.

• If the passenger occupant detection system seat belt latch is replaced, fill out the system registration sheet with the serial number and bar code label from the new seat belt latch and send it to the importer.

Tightening Specifications