Charge Air Cooler

Charge Air Cooler

Removing

- Remove the radiator. Refer to => [ Radiator ] Radiator.

- Remove front bumper cover.

- Remove the left and right air guides from the charge air cooler.

- Loosen the hose clamp - 2 -, lift the retaining clamp - 1 - just a little and remove the air guide hose.






Risk of injury from refrigerant.

• The air conditioning refrigerant circuit must not be opened.


Risk of damage to condenser and refrigerant lines and hoses.

• Do not stretch, kink or bend coolant lines and hoses.

- Remove the bolts - 1 - on the charge air cooler and - 2 - and on the condenser.





- Move the charge air cooler slightly to the rear, disengage it and then remove it downward.

Installing

• Tightening specifications, refer to => [ Charge Air Cooler Assembly Overview ] Charge Air Cooler Assembly Overview.

Installation is in reverse order of removal, note the following:

• The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

• Secure all hose connections with hose clamps appropriate for the model. Refer to the electronic parts catalog ETKA.

• In order to be able to securely mount the air guide hoses on their connectors, spray the screws on the previously used clamps with a rust remover.

- Install condenser.

- Install front bumper.

- Install the air guide hose with the connector coupling => [ Install the Air Guide Hoses with the Coupling ] Charge Air Cooler Assembly Overview.

- Install the radiator. Refer to => [ Radiator ] Radiator.