Right Coolant Pipe

Right Coolant Pipe

Special tools, testers and auxiliary items required

• Hose Clamps Up to 25 mm Diameter (3094)

• Drip Tray (VAS 6208)

• Hose Clip Pliers (VAS 6362)

Removing

- Remove the engine cover - arrows -.





- Loosen bolt - 1 -.





- Remove bolts - 2 - and nut - 3 -.

- Remove the hose bracket - 4 - from the fuel filter and then move the fuel filter - 7 - to the side with the fuel hoses - 5 - and - 6 - still connected.

- Remove the noise insulation - 1 -.





- Remove the front section of the right front wheel housing liner.





- Place (VAS 6208) under engine.





- Disconnect electrical connector - 3 - on engine coolant temperature sensor on radiator (G83).

- Loosen the hose clamps - arrows - and then remove the coolant hoses and (3094) from the right coolant pipe.

- Remove the nut - 1 - and bolt - 2 -. Then remove the right coolant pipe.

Installing

• Tightening specifications, refer to => [ Coolant Pipes, Coolant Temperature Sensors and Coolant Pump Assembly Overview ] Coolant Pipes, Coolant Temperature Sensors and Coolant Pump Assembly Overview.

Installation is in reverse order of removal, note the following:

• Secure all hose connections with hose clamps appropriate for the model. Refer to the electronic parts catalog ETKA.

- Install the front section of the front wheel housing liner.

- Install the noise insulation.

- Install the fuel filter.

- Check coolant level => [ Check coolant level. ] Procedures.