Blower Motor Resistor: Service and Repair

Fresh Air Blower Series Resistor with Fuse (N24)

- Remove the glove compartment.

- Remove screw clips - A - (different versions - C - and - D -) and remove insulation mat - B -.






- Disconnect harness connector - A - from series resistor - B -.






- Open locking mechanism - C - and slide the series resistor - B - to the right - arrow -.


Heat sink on Fresh Air Blower Series Resistor With Fuse may be hot.

- Remove series resistor - B - from heater (out of heating & A/C unit of manual climate control system).