Removal and Replacement
Line Routing, Exhaust System Components
Routing lines on the exhaust flap control module
1 Reduction Catalytic Converter
2 NOx Reduction Catalytic Converter
3 Direction of Travel
4 Line
• Note installation position
• Ensure seated tightly
5 Cable Bracket
6 Heat Shield
• Note installation position
• Replace if damaged
7 Exhaust Flap Control Module (J883) Connector
8 Exhaust Flap Control Module (J883)
Oxygen Sensor behind Three Way Catalytic Converter (G130) and Exhaust Gas Temperature Sensor 4 (G648) Wire Routing
1 Oxygen Sensor (O2S) behind Three Way Catalytic Converter (TWC) (G130)
2 Cable Bracket
3 Exhaust Gas Temperature (EGT) Sensor 4 (G648)
4 Distance: 100 mm
5 Line
• Note installation position
• Ensure seated tightly