Radiator and Coolant Fan Assembly Overview

Radiator and Coolant Fan Assembly Overview


Risk of injury from coolant fan starting by itself.

• Before working in fan shroud area, disconnect electrical connectors.






1 Coolant Fan (V7)

• With coolant fan control module (J293)

• Removing and installing, refer to => [ Coolant Fans ] Coolant Fans

2 Nut

• 5 Nm

3 Fan Rib

• Removing and installing, refer to => [ Fan Shroud ] Service and Repair

4 Upper Coolant Hose

• Lift the retaining clamp to remove

• Connect to the radiator

5 O-ring

• Replace

6 Radiator

• Removing and installing, refer to => [ Radiator ] Radiator

• Change coolant after replacing

7 O-ring

• Replace

8 Lower Coolant Hose

• Lift the retaining clamp to remove

• Connect to the radiator

9 Bolt

• 5 Nm

10 Nut

• 5 Nm

11 Bolt

• 5 Nm

12 Coolant Fan 2 (V177)

• Removing and installing, refer to => [ Coolant Fans ] Coolant Fans

Connect the Coolant Hose with the Connector Coupling





- Remove the old O-ring - 2 - in the coolant hose - 3 -.

- Coat new O-ring with coolant and install it in the coolant hose.

- Press the coolant hose onto the connection - 1 - until it engages audibly.

- Press the coolant hose on again and pull to make sure the connection is engaged correctly.