Divided Backrest Cover and Upholstery, Right 2/3 Backrest Without Center Armrest

Divided Backrest Cover and Upholstery, Right 2/3 Backrest Without Center Armrest






1 Seat Belt Guide Opening

2 Belt Webbing Guide

3 Belt Webbing

4 Lever

Red

5 Latch Trim

6 Mount

• For backrest

7 Peripheral Fastening Strips

8 Cover and Upholstery

Removing

- Remove the rear bench seat. Refer to => [ Rear Bench Seat ] Rear Bench Seat.

- Remove 2/3 right backrest. Refer to => [ Left 1/3 or Right 2/3 Backrest ] Left 1/3 or Right 2/3 Backrest.

- Remove the headrests. Refer to => [ Outer Headrests ] Outer Headrests.

- Remove center headrest. Refer to => [ Center Headrest ] Center Headrest.

- Lift latch trim - 5 - off.

- Remove seat belt guide - 2 - upward.

- Thread belt webbing - 3 - through opening - 1 - out of seat belt guide - 2 -.

- Remove peripheral retaining strips - 7 -.

- Pry cover over outer bearing - 6 - (quantity: 2).

- Raise cover and upholstery - 8 -.

- Press headrest guides - 9 - and - 10 - upward and out.

- Thread belt webbing - 3 - through upholstery.

- Remove cover and upholstery - 8 -.

Installation

Installation is reverse of removal, but note the following:

- Install headrest guide with button at left.

- After installing latch trim - 5 -, ensure red lever - 4 - moves easily.

9 Right Headrest Guide

• Quantity: 2

10 Left Headrest Guide with Button

• Quantity: 2