Storage Compartments, Version 1 With Smoking Package
Storage Compartments, Version 1 with Smoking Package
1 Center Section
2 Front Storage Compartment Cover
Removing
- Unclip front storage compartment cover - 2 -.
Installation
To install, perform the steps used in removal in reverse order.
3 Storage Compartment Cover
Removing
- Remove the front ashtray - 6 -.
- Unclip storage compartment cover - 3 -.
Installation
To install, perform the steps used in removal in reverse order.
4 Screws
3.5 Nm
• Quantity: 2
5 Omega Clips
• Quantity: 2
• Maintain installation position as shown in illustration
6 Front Ashtray
Removing
Manual Transmission:
- Remove cover with selector lever boot => [ Cover with Selector Lever Boot, Removing and
Installing ].
Automatic Transmission:
- Version I: remove the selector lever cover => [ Version I: Removing and Installing the Selector
Lever Cover ].
- Version II: remove the selector boot and cover => [ Version II: Removing and Installing the Selector
Lever Boot and Cover ].
All:
- Remove bolts - 4 - (quantity: 2).
- Remove omega clips - 5 -.
- Remove ashtray - 6 -.
Installation
To install, perform the steps used in removal in reverse order.
7 Center Console
8 Storage Compartment Trim
Removing
- Remove Climatronic Control Module (J255) (A/C Control Head).
- Remove the storage compartment trim - 8 -.
Installation
To install, perform the steps used in removal in reverse order.
9 Cover Light Lens
• Clipped into storage compartment trim - 8 -
Cover with Selector Lever Boot, Removing and Installing
- Open ashtray in center console.
- Remove cover - 1 - with selector lever boot - 2 - upward.
To install, perform the steps used in removal in reverse order.
Version I: Removing and Installing the Selector Lever Cover
- Open ashtray in center console.
- Remove selector lever cover upward - arrows -.
To install, perform the steps used in removal in reverse order.
Version II: Removing and Installing the Selector Lever Boot and Cover
- Unclip selector lever boot - 1 - on both sides and remove upward - arrows -.
- Grasp through opening and remove cover - 1 - upward - arrows -.
- Disconnect electrical connector.
To install, perform the steps used in removal in reverse order.
Omega Clips, Installation Location
1. Omega clips