Trunk / Liftgate Shock / Support: Service and Repair

Rear Lid Gas-Filled Strut

Removing

- Prop up and secure rear lid in open position.

- Using screwdriver, lift retaining spring - 3 - as shown and remove gas-filled strut - 1 - from upper ball head pin - 2 -.






• After completely removing gas-filled strut, ensure correct position when installing.

• Noise insulation component must be installed on the body side.

Installing

Installation is reverse of removal, noting the following:

- To install, press gas-filled strut onto ball head pins so that it engages in position.

- Ball head pin tightening specification 20 Nm-1 Nm