Seat Height Adjustment Motor V245 and V246

Seat Height Adjustment Motor V245 and V246

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Service Precautions.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove the seat. Refer to => [ Front Seat ] Front Seat.

- Attach the front seat to the fixture for seat repair (VAS 6136). Refer to => [ Installing Front Seat On VAS 6136 ] Installing Front Seat on VAS 6136.

- Remove tunnel side trim panel. Refer to => [ Sill Side Trim ] Sill Side Trim.

- Remove tunnel side trim panel. Refer to => [ Tunnel Side Trim ] Tunnel Side Trim.

- Remove front backrest. Refer to => [ Front Backrest ] Front Backrest.

- Disconnect electrical connector - 4 - on Driver Seat Height Adjustment Motor (V245) - 2 - or Front Passenger's Seat Height Adjustment Motor (V246).






- Disconnect seat pan upper frame - 1 - from lower frame - 3 -. Refer to => [ Seat Pan, Disassembling and assembling ] Seat Pan, Disassembling and assembling.

- Remove seat pan upper frame with cover and upholstery from lower frame.

- Remove the bolts - 2 -.






- Remove the driver seat height adjustment motor (V245) - 1 - or front passenger seat height adjustment motor (V246) toward center of seat - 3 -.

Installation

Install in reverse order of removal. Note the following:

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Service Precautions.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Make sure the clip - A - and plastic toothed segment collar - 2 - as well as locking pins - B arrows - are inserted correctly in holes on fitting - 1 -.






- Make sure the plastic toothed segment - 2 - is clipped to fitting - 1 - correctly.

Plastic toothed segment collar - arrow C - must contact fitting - 1 - evenly.

- Make sure the locking pins - A arrows - are inserted correctly in holes - B arrows - on link plate - 1 -.






• Make sure the connectors are installed all the way in and are secure.

- Switch on ignition.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect battery ground cable with ignition switched on.

- If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.

For the correct tightening specifications, refer to => [ Seat Height Adjustment Motors V245 and V246 Assembly Overview ] Seat Height Adjustment Motors V245 and V246 Assembly Overview