Removal and Replacement

Washer Fluid Reservoir, Lines and Nozzle Overview






1 Bolt

2 O-ring

• Replace if damaged.

3 Sealing Grommet

• Replace if damaged.

4 Washer Fluid Fill Neck

• For the washer fluid reservoir.

• Removing and installing, refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

5 Support Ring

6 Nut

• Threaded connection shared with the tower brace.

7 Cover

• For the fill neck.

8 Washer Fluid Line

• For the windshield washer system.

9 Right Spray Nozzle

• Depending on equipment, with the right washer nozzle heater (Z21).

• Removing and installing, refer to => [ Spray Nozzles ] Spray Nozzles.

• Adjusting, refer to => [ Windshield Spray Nozzles, Adjusting ] Adjustments.

10 Left Spray Nozzle

• Depending on equipment, with the left washer nozzle heater (Z20).

• Removing and installing, refer to => [ Spray Nozzles ] Spray Nozzles.

• Adjusting, refer to => [ Windshield Spray Nozzles, Adjusting ] Adjustments.

11 Washer Fluid Reservoir

• Removing and installing, refer to => [ Washer Fluid Reservoir ] Washer Fluid Reservoir.

12 Headlamp Washer System Pump (V11)

13 Sealing Grommet

14 Washer Fluid Line

• For the headlamp washer system.

15 Retaining Ring

• For the windshield washer pump (V5).

16 Windshield Washer Pump (V5)

• Removing and installing, refer to => [ Windshield Washer Pump (V5) ] Service and Repair.

17 Sealing Grommet

18 Bolt

19 Sealing Grommet

20 Windshield Washer Fluid Level Sensor (G33)

• Removing and installing, refer to => [ Windshield Washer Fluid Level Sensor (G33) ] Service and Repair.

Washer Fluid Reservoir, Tightening Specification and Sequence





- Tighten the washer fluid bolts - 3 and 4 - in the sequence specified:

- Tighten the bolt - 3 - to 7 Nm.

- Tighten the bolt - 4 - to 7 Nm.