Steering Column Switch Module Upper Trim

Steering Column Switch Module Upper Trim

Removing





- Move the steering wheel as far down as possible using the whole steering column adjusting range.

- Using a flat-head screwdriver, carefully unclip the gap cover - 2 - from the steering column switch module upper trim - 1 - - arrow A -.

- Rotate the steering wheel 90° out of the straight position.

- Carefully pry the steering column switch module upper trim off the lower trim - 3 - using a small screwdriver - B arrows -.

- Disengage the steering column switch module upper trim from the lower trim and remove it.

Installation





Installation is reverse of removal, but note the following:

- Engage the upper trim - 1 - in the lower trim - A arrows -.

- Ensure the lower trim pins engage in the opening at the upper trim retaining tab - B arrows -.