Ribbed Belt Tensioner

Ribbed Belt Tensioner

Removing






Risk of injury through fan turning on automatically.

• The radiator fan can come on even when the ignition is turned off, for example, caused by the heat still in the engine compartment.

- Remove the front engine cover - 1 - upward.

- Remove the bolt - 2 - on the left front coolant pipes.






• The installation location is shown with the engine removed.

• Ignore - 1 and 3 -.

- Remove the bolts - arrows - from the left front coolant pipes.






• The installation location is shown with the engine removed.

• Ignore - 1 -.

- Pivot the tensioner clockwise - arrow - to release the tension on the ribbed belt.






- Remove the ribbed belt from the tensioning element and release the tension on the tensioning element.

• Ignore (T10060 A).

- Remove the cover from the tensioner.






- Remove the bolt - 1 - and then remove the ribbed belt tensioning damper - 2 - from the cylinder block.

Installing

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to => [ Auxiliary Component Bracket Ribbed Belt Drive Overview ] Auxiliary Component Bracket Ribbed Belt Drive Overview.

- Install the ribbed belt. Refer to => [ Ribbed Belt ] Ribbed Belt.

- Install the left front coolant pipes. Refer to => [ Left Front Coolant Pipes ] Left Front Coolant Pipes.