AdBlue(R) Active Tank and Attachments Overview

AdBlue(R) Active Tank and Attachments Overview

• Installed location: Inside the right rear wheel housing, under the wheel housing liner






1 Union Nut

• Replace

• Use special wrench (T50014) for removing and installing

• Tightening => [ Install the reducing agent delivery unit in the active tank. Slide the heating element through the gap between the reducing agent delivery unit and installation opening into the active tank. ] AdBlue(R) Delivery Unit

2 AdBlue(R) Delivery Unit

• With reducing agent tank sensor (G684)

• With reducing agent temperature sensor (G685)

• With reducing agent tank heater (Z102)

• With filter

• Removing and installing, refer to => [ AdBlue(R) Delivery Unit ] AdBlue(R) Delivery Unit

3 Seal

• Replace

• Install dry

4 Bolt

• 9 Nm

5 Active Tank

• For reducing agent

• Removing and installing, refer to => [ AdBlue(R) Active Tank ] AdBlue(R) Active Tank

6 Transfer Line

• From the reducing agent transfer pump (V436) to the active tank

• Clipped in on fuel tank

7 Cap

8 Filling Line

• From the active tank to the passive tank

• Clipped in on fuel tank

9 Reducing Agent Pump (V437)

• With reducing agent pump heater (Z103)

• With reducing agent metering system pressure sensor (G686)

• Removing and installing, refer to => [ AdBlue(R) Pump ] AdBlue(R) Pump

Danger due to reducing agent leaking out.

• To prevent large amounts of reducing agent when opening the metering line, wait for the recirculation process to complete. Refer to Safety Precautions.

10 Metering Line

• From the reducing agent pump (V437) to the reducing agent injector (N474)

• Clipped in on fuel tank

Danger due to reducing agent leaking out.

• To prevent large amounts of reducing agent when opening the metering line, wait for the recirculation process to complete. Refer to Safety Precautions.

11 Bolt

• 1.8 Nm

12 Return Line

• Clip onto the active tank

13 Supply Line

• Clip onto the active tank