Transmission Output Shaft With Splines, Vehicles Without Vibration Damper

Transmission Output Shaft with Splines, Vehicles without Vibration Damper

Special tools, testers and auxiliary items required

• Pulling Hook (T20143)

• Subframe Support Assembling Device (T40239)

• Sealing grease (G 052 128 A1)

Procedure

• General repair instructions, refer to => [ Repair Information ] Repair Information.

• Clean working conditions for the automatic transmission. Refer to => [ Clean Working Conditions ] Clean Working Conditions.

- Remove the driveshaft.

- Pry off the dust ring - 1 -.





• The dust ring cannot be removed without destroying it.

- Shaft seal, transmission output shaft with splines, removing.





- Clean the running and sealing surface.

- Coat outer edge of seal with gear oil.

- Mount the guide sleeve (T40239/1), - 1 - on the transmission output shaft.





- Fill the space between the sealing and dust lip half way with sealing grease (G 052 128 A1).

- Install the shaft seal - 2 - over the guide sleeve - 1 - and onto the transmission output shaft.

• Installed position: The open side of the seal faces the transmission housing.

- Install the shaft seal using the (T40239), - 1 -. Do not bend the seal.





• Remove the guide sleeve (T40239/1) from the shaft seal carefully so that the sealing lip does not fold over.

- Install a new dust ring - 1 -.





- Install the driveshaft.