Conventional Bonded Rubber Bushing, 65 mm

Conventional Bonded Rubber Bushing, 65 mm

Special tools, testers and auxiliary items required

• Pressure plate (VW 402)

• Punch (VW 407)

• Press tool (3345)

• Subframe support assembling device (3347/1)

• Hold the guide link firmly in position while pressing bearing out and in.

Removing






- Remove guide link. Refer to => [ Guide Link ] Service and Repair.

- Mark the press-in depth on the mount - 1 - - arrow -.

• Use a waterproof felt-tip pen/marker to make the mark.

- Lay out the special tools as shown in the illustration.

- Press bushing - 1 - out of guide link - 2 -.

Installing






- Transfer the installation depth marking from the old bearing to the new one - arrow -.

- Apply a thin coat of assembly paste on the mount. Allocation, refer to the Electronic Parts Catalog (ETKA).

Bushing Installation Position





- A - = 90° +/- 5°

- Insert bearing - 1 - into guide control arm - 2 -, observe installation position when doing this.






- Lay out the special tools as shown in the illustration.

• Make sure that the mount does not get installed crooked when pressing it in to place.

- Press bearing - 1 - into guide control arm - 2 -.

- Pay special attention to the press-in depth mark you made during installation - arrow -.

- Check installation position of bearing - 1 - in guide control arm - 2 -.






- A - = 90° +/- 5°

- Check rim offset of bearing - 1 - in guide control arm - 2 -.






The - a - and - b - dimensions must be the same.

- If the - a - and - b - dimensions are different, press on the mount some more - 1 -.

- Install guide control arm. Refer to => [ Guide Link ] Service and Repair.