Front Belt Latch

Front Belt Latch

Removing






- Remove the front seat:

• Standard seat and Sport seat (manually adjustable) as well as front folding seat - passenger seat, refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.

• Standard seat, Sport seat (power) and Comfort seat, refer to => [ Power Standard Front Seat ] Power Standard Front Seat.

Seat Occupied Recognition for Passenger Airbag Deactivation


Replace the passenger occupant detection system seat belt latch each time the passenger belt tensioner deploys.

All vehicles

- Disconnect the connector - 3 - and free up the wire - arrows -.

- Remove bolt - 1 - and remove belt latch - 2 -.

Installation

Installation is reverse of removal, but note the following:

- Replace the seat belt latch bolt.

Front seat belt latch installation position






- Install the seat belt latch - 1 - so that the tab - arrow A - fits into the opening - arrow B - on the seat pan frame - 2 -.

Seat Occupied Recognition for Passenger Airbag Deactivation

- If seat occupied recognition passenger airbag deactivation seat belt latch is replaced, seat occupied recognition registration sheet must be filled out with serial number and bar code sticker from new seat belt latch and sent to the sales center or to the importer.

All vehicles

• Make sure the connectors are installed all the way in and are secure.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle diagnostic tester.

Tightening specifications, refer to => [ Front Belt Anchor Overview ] Front Belt Anchor Overview.