Cigarette Lighter

Cigarette Lighter

Special tools, testers and auxiliary items required

• Release Tool for Cigarette Lighter (T40148)

Removing






- Remove the cigarette lighter illumination bulb (L28). Refer to => [ Cigarette Lighter Illumination ] Cigarette Lighter Illumination.

• The release tabs - 2 - on the release tool for cigarette lighter (T40148) must engage in the openings in the cigarette lighter housing- 3 - - arrow - and the threaded pin - 1 - must slide down as far as the stop.

- Slide the (T40148) into the cigarette lighter - 1 - as far as the stop.






- Rotate the thumbwheel - 2 - on the (T40148) clockwise as far as the stop.

• The piston - 2 - is pulled upward and the release tabs - 1 - on the (T40148) spread - arrows -.






- Remove the cigarette lighter from the lighting ring using the (T40148).

- Release the retaining clips - arrows -.






- Remove the cigarette lighter with the illumination ring - 1 - from the front ashtray - 2 -.

Installing


Risk of injury.

• After removing the release tool, check to see if the lighter retaining tabs are bent.

• If the retaining tabs are bent, gently bend them back so the lighter does not slide out.

Install in reverse order of removal, observing the following:

- Remove the support - 1 - on the (T40148).

- Slide the piston down and hold it in place.

- Rotate the thumbwheel - 4 - on the (T40148) counterclockwise, in the direction of the - arrow -. This loosens the release tabs - 2 - on the cigarette lighter - 3 - so the (T40148) can be removed.