Backrest Cover and Upholstery

Backrest Cover and Upholstery

• The work procedure is based on the two thirds left rear seat backrest and one third right rear seat backrest.

Removing






- Remove the rear seat. Refer to => [ Seat Frame ] Seat Frame.

- Remove the rear headrests. Refer to => [ Headrest ] Headrest.

- Remove rear headrest guides. Refer to => [ Headrest Guide ] Headrest Guide.

- Remove the rear center armrest. Refer to => [ Center Armrest ] Center Armrest.

- Remover the rear seat belt guide in the center. Refer to => [ Rear Seat Belt Cover in Center Seating Position ] Rear Seat Belt Cover In Center Seating Position.

- Remove the center rear belt anchor. Refer to => [ Rear Seat Belt Anchor in Center Seating Position ] Rear Seat Belt Anchor in Center Seating Position.

- Pry off the retaining strip - 2 - on the back side of the backrest frame - 3 - and remove it all the way around - arrow -.

- Disengage the retaining strip - 4 - on the front side of the backrest frame.

- Remove the lower cover and cushion - 1 - between the seat frame and backrest frame.

Installation

Installation is reverse of removal, but note the following:

- Make sure the retaining strips engage correctly and the cover is not wrinkled.