Exterior Rearview Mirror Housing

Exterior Rearview Mirror Housing






1 Exterior Rearview Mirror Housing

• Removal:

- Mirror glass removed. Refer to => [ Exterior Rearview Mirror Glass ] Exterior Rearview Mirror Glass.

- Remove the bolts - 2 -.

- From the inside, remove the housing upward at the lower front edge.

- Remove the housing upward and out of the guides for the adjusting unit mount.

- Disconnect the turn signal connector.

- Remove the housing.

2 Lane Change Assistance Warning Lamp

3 Bolt

• 1 Nm

4 Mirror Adjusting Unit Mount

• Removal and Installation, refer to => [ Mirror Adjusting Unit Mount ] Mirror Adjusting Unit Mount

5 Driver Exterior Mirror Turn Signal Lamp (L131)

Removing housing





- From the inside, push the housing - 1 - on the front lower edge upward and against the bottom of the adjusting unit mount and then pull it off the retaining hooks - arrows -.

Installing

- When the installing, the guides must be pushed correctly into the brackets - arrows b - so that the retaining hooks - arrows a - can engage.





- The front edge of the housing must engage with the bottom of the bracket.

• Tightening specification, refer to => [ Exterior Rearview Mirror Assembly Overview ] Exterior Rearview Mirror Assembly Overview.

- Install the mirror glass.