Transmission Mount

Transmission Mount

Special tools, testers and auxiliary items required

• Engine Support Bridge (10 - 222 A)

Removing


Risk of destroying electronic components when disconnecting the battery.

• Follow the procedure for disconnecting the battery.

- Remove cover - 1 - from above battery, by pressing the release tabs - arrow -.






- Disconnect and remove the battery only with the ignition switched off.

Vehicles with an Air Filter Housing in front of the Battery

- Remove the entire air filter housing.






Continued for All Vehicles

- Remove the bolts - arrows - and remove the battery tray - 1 -.






- Remove engine cover.

- Position (10 - 222 A) with (10 - 222 A /3) on to bolted flanges of fender.






- Hook the hooks of the spindles into the lifting eyes.

- Pretension the engine evenly using both spindles, but do not lift.

- Remove bolts - arrows -.






- Open wiring guide bracket - arrows -.






- Cut cable ties - 1 - and press electrical wires to side.

- Unclip wiring guide.

- Remove bolts - 1 - and remove transmission mount - A -.






Installing

• Tightening specifications. Refer to => [ Subframe Mount Overview ] Description and Operation.

Install in reverse order, paying attention to the following:

- Install transmission mount - A - on long member.









Risk of damaging threads in transmission bracket - 1 - by inserting bolts crooked.

• Before installing bolts - arrows -, transmission bracket - 1 - and transmission mount support arm - 2 - must be absolutely parallel to each other. If necessary, raise rear of transmission with trolley jack.

- Raise transmission with engine support bridge spindle until transmission bracket - 1 - touches transmission mount support arm - 2 -.

- Adjust subframe mount.

- Tighten the transmission mount support arm - 2 - on transmission bracket.

- Remove (10 - 222 A) from engine.

- Install the engine cover.

- Install the battery tray and the battery.

- Install the air filter housing.