Transmission Mount

Transmission Mount

Special tools, testers and auxiliary items required

• Engine Support Bridge (10 - 222 A)

• Hook (10 - 222 A /10)

• Engine Support Basic Set (T40091)

• Engine Support Supplement Set (T40093)

Removing

Proceed as follows:

- Disconnect electrical harness connector - 3 - from mass air flow (MAF) sensor (G70).





- Open clips - 1 and 2 - and remove air guide hose from mass air flow (MAF) sensor (G70).

- Remove front air intake nozzle from lock carrier - 4 -.

- Remove engine cover.

- Position engine support bridge (10 - 222 A) with the following tool components on upper edges of web plate:





• Bracket for engine (10 - 222 A /1), qty. 2

• Adapter (10 - 222 A /4)

• Connectors (T40091/3), qty. 2

- Install left adapter (T40093/3-2) and right adapter (T40093/3-3) on supports (T40093/3).





- Remove Ground (GND) wire from left long member.

- Remove left and right connecting bolt for front part of long member.

- Install adapters on long members with bolts that were removed earlier - arrow -.

• The left side of the vehicle is shown in the illustration.

- Insert square tube (T40091/1) with connectors (T40093/4) in connector (T40091/3) and supports (T40093/3) as shown in illustration.





- Slide supports (T40091/2) with slide (T40093/5) into both connectors (T40093/4).





Risk of an accident due to loose support bridge parts.

• Secure support (T40091/2) with pins and splints from connector (T40093/4).

• Secure connector and supports with locking bolts.

- Install bracket with spindle and hook (10 - 222 A /10) on slide and engine lifting eye.

- Pretension engine/transmission assembly with spindle, but do not lift.

- Remove bolts - arrows -.





- Open wiring guide bracket - arrows -.





- Cut cable ties - 1 - and press electrical wires to side.

- Unclip wiring guide.

- Remove bolts - 1 - and remove transmission mount - A -.





Installing

• Tightening specifications, refer to => [ Subframe Mount Assembly Overview ] Description and Operation.

Installation is in reverse order of removal, note the following:

- Tighten transmission mount - A -.

Risk of damaging threads in transmission mount support arm due to bolts inserted crooked.

• Before installing bolts - arrows -, transmission plate and transmission mount support arm must be absolutely parallel to each other. If necessary, raise rear of transmission with trolley jack.







- Raise transmission with engine support bridge spindle until transmission plate touches transmission mount support arm.

- Adjust subframe mount.

- Tighten transmission mount support arm on transmission plate.

- Remove Engine Support Bridge (10 - 222 A) from engine.