Rear Headrest

Rear Headrest

Removing






Follow the safety precautions for the rollover protection. Refer to => [ Rollover Protection Additional Safety Precautions ] Service Precautions.

- Open the convertible top until the displayed position of the top and the convertible top compartment cover is reached.

- Support the convertible top with a suitable wood stick.

- Disconnect the ground cable from the battery.

- Remove the screws - 2 - and remove the head restraint - 1 - and bracket.





Installation


Follow the safety precautions for the rollover protection. Refer to => [ Rollover Protection Additional Safety Precautions ] Service Precautions.

Installation is reverse of removal, but note the following:


Make sure no one is standing near the rollover protection when reconnecting the battery. Stand at least 1 meter away.

- Connect the ground cable to the battery.

- ALWAYS perform an output diagnostic test under "Guided Functions" after repairing the rollover protection and only after all work procedures are completed (also if a new rollover protection was installed).

Tightening specifications, refer to => [ Rear Head Restraints Assembly Overview ] Rear Head Restraints Assembly Overview.