Seat Rail Cover

Seat Rail Cover

• The procedure for removing and installing is described on the driver seat sill side seat rail cover. The procedure is similar for the tunnel side seat rail cover.

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)

Removing


• Follow the safety precautions for pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove front seat:

• Standard and Sport Manual Seat. Refer to => [ Manual Standard Front Seats ] Manual Standard Front Seats.

• Standard and Sport Power Seat, Comfort Seat and Super Sport Seat. Refer to => [ Power Standard Front Seats ] Power Standard Front Seats.

- Unclip the retaining tabs - 3, 4 and 5 - on the cover - 2 - from the seat rail.





- Remove the cover - 1 - forward parallel to the seat rail.

Installation


• Follow the safety precautions for pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

• Ensure that electrical connections are pushed in as far as stop and engage with a click.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.