Headrest Cover and Upholstery, with Locking Mechanism

Headrest Cover and Upholstery, with Locking Mechanism


• It is only possible to replace the cover on the headrest with leather cover. It is not possible to replace the cover on a fabric headrest because the cover is filled with foam and also serves as the casing for the upholstery.

• The headrest support is built into the upholstery. Both components are attached to each other and cannot be separated.

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)

Removing


• Follow the safety precautions for pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove headrests:

• => [ Headrests with Locking Mechanism ] Headrests with Locking Mechanism.

• => [ Power Headrests ] Power Headrests.

- Open the side locks - arrows - on the cover - 1 -.





- Insert the trim removal wedge (3409) in - direction of arrow A - between the cover zipper - 1 -.





- Bend the lower U-channel - 3 - in the - direction of arrow B -.

- Pull the upper side of the cover with the flat channel - 2 - out of the U-channel.

- Open the zipper by inserting the trim removal wedge (3409) between the zipper and the cover.





- Bend the lower U-channel - 1 - in the - direction of arrow A -.

- Pull the upper side of the cover with the flat channel - 2 - out of the U-channel.

• The cover must be completely open to remove the upholstery.

- Remove upholstery - 1 - from cover - 2 -.





Installation

- Insert the padding - 2 - in the cover - 2 - and make sure it fits properly.

- Insert headrest mount in upholstery with cover.

- Closes the main zipper by moving the upper cover flat profile - 1 - - 2 -.





- Slide the edge of the fabric edge with the flat channel into the U-channel - 5 -.

- Closing the side locks is similar to the closing the main lock.

- After closing the main zipper and the side zippers with a needle or other pointed object, line up the cover and the profiles.

- Ensure the cover sits on the upholstery - 3 - without any wrinkles and without seam markings.

Further installation is performed in the reverse order of removal.