Anti-roll Bar Guide

Anti-roll Bar Guide

• Removal and installation are same for right and left.

Removing


Follow the safety precautions for the rollover protection. Refer to => [ Rollover Protection Additional Safety Precautions ] Service Precautions.

- Perform an output diagnostic test under "Guided Functions" .

• The anti-roll bars are extended.

- Disconnect the ground cable from the battery.

- Release the hooks - 1 and 2 - with a small screwdriver and remove the guide - 3 - downward - arrow -.





Installation


Follow the safety precautions for the rollover protection. Refer to => [ Rollover Protection Additional Safety Precautions ] Service Precautions.

Installation is reverse of removal, but note the following:

- Press on the rollover protection guide back on until it engages audibly.

- Return a deployed rollover protection back into it stored position. Refer to => [ Deployed Rollover Protection, Returning to Stored Position ] Deployed Rollover Protection, Returning to Stored Position.


Make sure no one is standing near the rollover protection when reconnecting the battery. Stand at least 1 meter away.

- Connect the ground cable to the battery.

- ALWAYS perform an output diagnostic test under "Guided Functions" after repairing the rollover protection and only after all work procedures are completed (also if a new rollover protection was installed).