Upper Oil Pan Overview
Upper Oil Pan Overview
1 Spring
2 Support
3 Oil Pump Input Shaft
4 Upper Oil Pan
• Removing and installing, refer to => [ Upper Oil Pan ] Upper Oil Pan
5 Bracket
• For the electrical wiring harness
6 Bolt
• 9 Nm
7 Oil Pressure Regulation Valve (N428)
• Removing and installing, refer to => [ Oil Pressure Regulation Valve ] Service and Repair
8 Bolt
• 9 Nm
9 Sealing Piece
• Replace
• 2 pieces
10 Bolt
• Tightening specification and sequence, refer to => [ Ribbed Belt Pulley Side Sealing Flange - Tightening Specifications and Sequence ] Seal and Sealing Flange, Pulley Side Overview
11 Crankshaft Shaft Seal, Belt Pulley Side
• Removing and installing, refer to => [ Crankshaft Shaft Seal, Belt Pulley Side, Replacing ] Crankshaft Shaft Seal, Belt Pulley Side, Replacing.
12 Right Idler Roller for Ribbed Belt
• Pay attention to the installed position
13 Idler Roller Cover
14 Bolt
• Tightening specifications => [ (Item 12) Bolt ] Ribbed Belt Drive Overview
15 Sealing Flange (belt pulley side)
• Removing and installing, refer to => [ Sealing Flange, Belt Pulley Side ] Service and Repair
16 O-ring
• Replace
17 Oil Pressure Switch (F22)
• 20 Nm
• Switching pressure 2.5 to 3.2 bar
• 2-pin, gray insulation
• Checking in "Guided Functions" -> vehicle diagnostic tester.
• Removing and installing, refer to => [ Oil Pressure Switch (F22) ] Oil Pressure Switch (F22)
18 Seal
• Replace
19 Bolt
• 9 Nm
20 Oil Dipstick
21 O-ring
• Replace
22 Guide Tube for oil Dipstick
23 Bolt
• 9 Nm
24 O-ring
• Replace
25 O-rings
• Replace
26 Gasket
• Replace
27 Bolt
• 9 Nm
28 Oil Return Pipe
29 O-ring
• Replace
30 Gasket
• Replace
31 Alignment Bushing
• 2 pieces
32 Bolt
33 Bolt
• Tightening specifications => [ Engine to Automatic Transmission 09D ] Engine, Installing
34 Locking Bolt for the "TDC" Marking.
• 35 Nm
• Use a long hex socket wrench with a ball head for removing and tightening
35 Seal
• Replace
Upper Oil Pan, Tightening Specifications and Sequence
- Tighten bolts in 2 stages as follows:
