Drive Belts, Mounts, Brackets and Accessories: Service and Repair

Accessory Assembly Bracket

Special tools, testers and auxiliary items required

• Locking Pin (T10060A)

Removing

- Disconnect the electrical connector on the mass airflow (MAF) sensor (G70) - 3 -.






- Open clips - 1 and 2 - and remove air guide hose from MAF sensor.

- Remove front air intake connector on lock carrier - 4 -.

- Remove engine cover.

- Pull the Evaporative Emission (EVAP) canister with connected lines upward - arrow - out of the retainer and lay it aside.






• Before removing the ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed turning direction can cause damage to the belt under operating conditions.

- Pivot the ribbed belt tensioner in direction of - arrow - to relieve tension on ribbed belt.






- Secure tensioning element using the (T10060A).






- Remove ribbed belt.

- Remove ribbed belt tensioner - arrows -.






- Discharge the refrigerant circuit.

- Remove the generator.

- Remove center noise insulation fasteners - 1 to 4 -.






- Remove the right noise insulation - arrows -.






- Remove noise insulation frame - arrow -.






- Remove the A/C compressor.

- Remove the accessory assembly bracket - bolts - 1 through 6 -.






Installing

Installation is performed in the reverse order of removal, noting the following.

• For the correct tightening specifications, refer to => [ Ribbed Belt and Assembly Bracket Overview ] Ribbed Belt and Assembly Bracket Overview.

- Tighten the bolts in the sequence - 1 through 6 -.






- Install the generator.

- Install A/C compressor.

- Install the ribbed belt. Refer to => [ Ribbed Belt ] Ribbed Belt.

- Connect the battery.