Crankshaft Pulley

Crankshaft Pulley

Removing

- For vehicles with auxiliary heater, remove bolts - arrows - for exhaust pipe of parking heater/auxiliary heater on noise insulation.





- Loosen quick-release fasteners - 1 - and - 2 - and remove front noise insulation.





- Bring lock carrier into service position. Refer to => [ Lock Carrier, Moving into Service Position ] Lock Carrier, Moving Into Service Position.

- Remove ribbed belt. Refer to => [ Ribbed Belt ] Ribbed Belt

- Unfasten crankshaft belt pulley.





• To loosen and tighten the crankshaft belt pulley, counter-hold at the central bolt using a box-end wrench.

Installing

Installation is in reverse order of removal, note the following:

- Only install crankshaft belt pulley with original bolts.





• Only possible to install in one position: The hole - arrow - in crankshaft belt pulley must be positioned over protrusion on toothed belt sprocket

- Install lock carrier with attachments. Refer to =>
Radiator Support Radiator Support

- Place torque support stop onto rubber buffer for torque support under its own weight and tighten nuts - arrows -.





- Install front bumper cover.

- Check headlight adjustment.

Tightening Specifications