Trunk / Liftgate Shock / Support: Service and Repair

Gas-Filled Strut

Removing





• When removing or installing the gas-filled strut, push back the opened rear lid only slightly so as to avoid damaging components.

- Lift retaining springs in succession on both ends using screwdriver and remove gas-filled strut - 1 -.

Installing

- Clip in gas-filled strut at bottom first, then at top.

- Install with tube end of strut at rear lid.

Gas-filled strut, venting





CAUTION!
Clamp only within this area, otherwise accident could occur!

- Clamp gas-filled strut in vice area - x - = 50 mm (2 in.).

- Cover area of sawn portion with a rag to absorb oil spraying out.

CAUTION!
Always wear eye protection when performing this procedure.

- Cut through cylinder of gas strut within first third of cylinders overall length using piston rod end of cylinder as reference point.