Muffler: Service and Repair

Center Muffler and Rear Muffler, Separating

• A separating point has been provided in the connecting pipe for individual replacement of the center or rear muffler.

• The separating point is marked by depressions around the circumference of the exhaust pipe.

Special tools, testers and auxiliary items required

• Chain Pipe Cutter (VAS 6254)

Procedure






- Separate exhaust pipe at a right angle at the separating point - arrow 2 - using a (VAS 6254).

- Position the clamping sleeve - 4 - at the side markings - arrow 1 - and - arrow 3 - when installing.

- Install the clamping sleeve so that the ends of the bolt do not extend beyond the lower edge of the clamping sleeve.






• The threaded connections face downward.

- Install exhaust system free of stress. Refer to => [ Exhaust System, Aligning ] Procedures.