Hose Connections with Connector Couplings, Assembling

Hose Connections with Connector Couplings, Assembling

Connector coupling sealing ring can be damaged if securing clamp is in locked position when installing. This would result in a leak. Follow assembly instructions.

Removing

- Release connector coupling by pulling locking clip - arrow -. Separate hose/tube without assistance from tools.






Installing

- When replacing sealing ring, lay ring in charge air hose groove. Make sure the seal is seated properly all around and is not twisted.

- Oil sealing surfaces and sealing ring.

- Bring securing clip into release position - 1 -.






- Slide charge air hose into clutch as far as stop.

- Bring securing clip into lock position - 2 - and then press charge air hose back again.

- Check for correct seating and proper locking of connector by pulling on hose.