Valve Cover: Service and Repair

Cylinder Head Cover

Removing

Special tools, testers and auxiliary items required

• Ignition Coil Puller (T40039)

- Remove engine cover - arrows -.





- Remove bolts - arrows -.





- Remove bolts - 1 -.





- Disconnect connector - 2 - from ignition coils and free up cable.

- Remove ignition coils with power output stages - 2 - using Ignition Coil Puller (T40039).





- Disconnect EVAP line from cylinder head cover - 1 -.





- Remove the valve housing from the cylinder head cover - arrows -.

- Unfasten the crankcase ventilation line from the turbocharger - 1 -.





- Disconnect the EVAP line to the turbocharger from the cylinder head cover - 2 -.

- Loosen cylinder head cover from outside toward the inside.

- Remove cylinder head cover.

Installing

Installation is in reverse order of removal, note the following:

• Replace cylinder head cover gaskets if damaged.

- Tightening sequence => [ Cylinder head cover tightening sequence ] Cylinder Head Assembly Overview

- Observe the correct positioning of the upper toothed belt cover.

Tightening Specifications