Convertible Top Hydraulic Lines to Connecting Plate

Convertible Top Hydraulic Lines to Connecting Plate

Special tools, testers and auxiliary items required

• Hydraulic Line Connect Tool (3335)

Removing





Follow cleanliness rules => [ Convertible Top Hydraulic System Clean Working Conditions ] Convertible Top Hydraulic System Clean Working Conditions.

Hydraulic pump connection table.

- Remove hydraulic pump => [ Convertible Top Hydraulic Unit and Pump ] Convertible Top Hydraulic Unit and Pump.

- Remove center and side bulkhead trim.

- Raise spring washer - 1 - on hydraulic lines to be removed (supply and return) over collar on connecting piece with a small screwdriver and remove.





Installing





- Place hydraulic line with connecting piece through connecting plate.

- Place Hydraulic Line Connect Tool (3335) sleeve - 1 - over connecting piece.

- Slide spring washer - 2 - onto sleeve and press it on completely with Hydraulic Line Connect Tool (3335).

• Spring washer - 2 - must slide completely over collar on connecting piece - 1 -.





- Coat sealing ring - 3 - with hydraulic oil and slide it onto connecting piece.

Hydraulic pump connection table





Connections shown from hose side out.

1 - Main drive motor hydraulic cylinder

11 Left piston rod side
12 Left piston side
13 Right piston rod side
14 Right piston side

2 - Bracket drive motor hydraulic cylinder

21 Left piston rod side
22 Left piston side
23 Right piston rod side
24 Right piston side

3 - Convertible top compartment cover hydraulic cylinder

31 Left piston rod side
32 Left piston side
33 Right piston rod side
34 Right piston side

Tightening torques => [ Convertible Top Hydraulic System Assembly Overview ] Convertible Top Hydraulic System Assembly Overview.