Seat Pan Cover and Cushion, Sport Seat
Seat Pan Cover and Cushion, Sport Seat
Separating from Seat Pan
1 - Cover and Cushion
• Removing
- Remove seat. Refer to => [ Seat ] Power Front Memory Seats.
- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).
- Attach the front seat to the fixture for seat repair (VAS 6136).
- Remove side trim on sill side. Refer to => [ Side Trim, Sill Side ] Power Front Memory Seats.
- Remove side trim on tunnel side. Refer to => [ Side Trim, Tunnel Side ] Power Front Memory Seats.
- Remove the backrest. Refer to => [ Front Backrest ] Power Front Memory Seats.
- Remove bolts - 3 - (Qty. 2).
- Remove bracket - 2 -.
- Remove clip - 4 -.
2 - Retainer
3 - Screws, (Qty. 2)
4 - Clip
1 - Seat Cushion Extension
• Pry out grip channels - 3 - all around.
• Disengage tab - 5 - on underside of seat.
• Disconnect connector for seat heater - 4 -.
• Pull out seat cushion extension - 1 - completely.
• Remove nuts - 2 - (Qty. 4).
• Remove cover and Cushion.
- For vehicles with LATCH bracket and new cover - 1 -, cover must be cut in at LATCH bracket.
2 - Nuts (Qty. 4)
• 35 Nm
3 - Peripheral Fastening Strips
4 - Seat Heating Connector
5 - Tab
Seat Cushion Extension, Separating from Cover and Cushion
1 - Clips (Qty. 3)
2 - Fastening Strips (Qty. 5)
3 - Seat Cushion Extension
• Pry out grip channels - 2 - (Qty. 5).
• Pry out clips - 1 - (Qty. 3).
• Remove seat cushion extension - 3 -.
Cover, Separating from Cushion
1 - Cable Ties (Qty. 2)
2 - Rods (Qty. 2)
• Loosen cable ties - 1 - (Qty. 2).
• Pry out rods - 2 - (Qty. 2).
1 - Cover
• Pry out grip channels - 3 - from plastic clips - 2 - using a screwdriver.
• Remove cover - 1 -.
- For vehicles with LATCH bracket and new cover - 1 -, cover must be cut in at LATCH bracket.
2 - Plastic Clips
3 - Fastening Strips
• Installing
- Replace damaged plastic clips.
- First press in transverse beam plastic clips.
- To install, perform the steps used in removal in reverse order.