Pedal Cluster Assembly Overview

Pedal Cluster Assembly Overview





1 Mounting bracket

• Removing and installing, refer to => [ Master Cylinder ] 01X Transmission.

2 Pivot pin for clutch and brake pedal

3 Retaining clip

4 Bolt - 25 Nm

5 Brake pedal

• Maintenance free bearing, do not grease.

6 Clutch pedal switch (F 36)

• Removing and installing, refer to => [ Clutch Pedal Switch ] 01X Transmission.

• Only installed one time.

• Replace.

7 Bolt - 5 Nm

• Secures clutch and brake pedal pivot pin.

8 Clutch pedal

• Removing and installing, refer to => [ Master Cylinder ] 01X Transmission.

9 Retaining clip

10 Retaining clip

• Removing and installing => [ (Item 9) Retaining clip ] Hydraulic System Assembly Overview.

11 Bolt - 20 Nm

12 Master cylinder

• Removing and installing, refer to => [ Master Cylinder ] 01X Transmission.

• Gasket - arrow - must not be removed.

13 Over center spring

• Black side points toward clutch pedal.

• Removing and installing, refer to => [ Over Center Spring ] Over Center Spring.

• For correct version see.

14 Clutch pedal starter interlock switch (F194)

• Only for USA.

• Engine can only be started when clutch is fully depressed ( clutch pedal starter interlock switch activated).

• Removing and installing, refer to => [ Installing ] 01X Transmission.

• Replace.

• Only install one time.

15 Torx bolt, 25 Nm

• For securing brake master cylinder/brake servo to mounting bracket.