Seat Pan Cover and Cushion, Standard Seat

Seat Pan Cover and Cushion, Standard Seat

Separating from Seat Pan





1 - Cover and Cushion

• Removing

- Remove seat. Refer to => [ Seat ] Power Front Memory Seats.

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Attach the front seat to the fixture for seat repair (VAS 6136).

- Remove side trim on sill side. Refer to => [ Side Trim, Sill Side ] Power Front Memory Seats.

- Remove side trim on tunnel side. Refer to => [ Side Trim, Tunnel Side ] Power Front Memory Seats.

- Remove the backrest. Refer to => [ Front Backrest ] Power Front Memory Seats.

- Remove bolts - 3 - (Qty. 2).

- Remove bracket - 2 -.

- Disconnect connector for seat heater - 7 -.

- Remove clip - 4 -.

- Pry out grip channels - 5 - all around.

- Disengage tab - 6 -.

- Remove cover and cushion - 1 -.

- For vehicles with LATCH bracket and new cover - 1 -, cover must be cut in at LATCH bracket.

2 - Retainer

3 - Screws, (Qty. 2)

4 - Clip

5 - Peripheral Fastening Strips

6 - Tab

7 - Seat Heating Connector

Cover, Separating from Cushion





1 - Cover

• Pry out grip channels - 3 - from plastic clips - 2 - using a screwdriver.

• Remove cover - 1 -.

- For vehicles with LATCH bracket and new cover - 1 -, cover must be cut in at LATCH bracket.

2 - Plastic Clips

3 - Fastening Strips

• Installing

- Replace damaged plastic clips.

- First press in transverse beam plastic clips.

- To install, perform the steps used in removal in reverse order.