Selector Shaft Seal

Selector Shaft Seal

Special tools, testers and auxiliary items required

• Pry Lever - Rmv Outside Mirror (80-200)

• Thrust piece (T10135)

Procedure

• General repair notes. Refer to => [ General Repair Information ] General Repair Information.

• Rules of cleanliness for working on automatic transmissions. Refer to => [ Clean Working Conditions ] Clean Working Conditions.

- Place selector lever in position "P".

- Remove left transmission support. Refer to => [ Left and Right Transmission Mount and Transmission Support ] Service and Repair.

- Press ball socket - 1 - of the selector lever cable off from the selector shaft lever using the pry lever ( 80-200).





• Take care not to bend or kink selector lever cable.

• Disregard - 2 -.

- Drive out the roll pin - 1 - at selector shaft lever - 2 - in direction indicated - arrow - until selector shaft lever can be pulled off selector shaft.





- Pierce shaft seal with a small screwdriver and pull out.





- Lubricate outer circumference and space between sealing ring sealing lips with ATF.

- Press new shaft seal onto selector shaft.

• Installation position: The open side of the seal faces the transmission.

- Press on new shaft seal as far as stop using Thrust Piece (T10135) and assembly lever - A -, ensuring shaft seal does not distort.





• To prevent assembly lever from slipping when pressing in seal, place a slip-resistant base (e.g. piece of rubber) between assembly lever and subframe - arrow -.

- Drive spring pin back onto removed selector shaft lever in opposite direction to lever.

- Slide selector shaft lever onto shaft and drive in spring pin.

- Carefully press selector lever cable - 1 - onto selector shaft lever - 3 -.





• Do not bend selector shaft lever when pressing off, otherwise selector mechanism can no longer be adjusted correctly.

• Disregard - 2 -.

- Check ATF level. Refer to => [ ATF, Checking Level and Correcting ] ATF, Checking Level and Correcting.