Wiring Harness: Service and Repair

Wiring Harness

Removing

- Removing valve body. Refer to => [ Valve Body ] Valve Body.

- Lever out retainer straps of connectors at solenoid valves and pressure control valves using a small screwdriver and disconnect connectors - A - in sequence.





- Unhook wiring harness at side retainer straps - B - of valve body.

- Turn valve body on its back side and loosen connector - 1 - at Pressure Control Valve 1 for Auto. Transmission (N215).





- Remove retaining clip (arrow A) and unclip wiring harness from retaining clip (arrow B).

Installing

Installation is reverse of removal, noting the following:

- When installing, connect connectors of wiring harness to the corresponding solenoid valves and pressure control valves.

- Clip wiring harness into the respective retaining clips. In case of deviations, the wiring harness can be pinched during installation of the valve body.

- Installing valve body. Refer to => [ Valve Body ] Valve Body.

- Fill up ATF. Refer to => [ ATF, Changing or Filling after Repairs ] .