01VA Transmission

Transmission Mounts

Special tools, testers and auxiliary items required

• Transmission support (3282)

• Adjustment plate (3282/19)

• Engine/Transmission Jack (VAG 1383 A)

Removing

• Transmission must be supported as indicated when both transmission supports are removed. Transmission does not need to be supported this way when only one of the transmission supports is being removed.

- Prepare transmission support (3282) for Automatic Transmission 01V with adjustment plate (3282/10 ) and place it on the Engine/Transmission Jack ( VAG 1383 A).

• The symbols on the adjustment plate indicate the necessary mounts for Automatic Transmission 01V and the arrow points toward front of vehicle.

- Roll Engine/Transmission Jack (VAG 1383 A) with transmission support (3282) under transmission, align adjustment plate parallel to transmission and support transmission.

- Secure transmission on transmission support ( 3282) using bolt - A -.

• If transmission support (3282) is not available, transmission can be supported using the Engine/Transmission Jack (VAG 1383 A) and the 1359/2 universal mount.

Right transmission support

- Remove bolts - B -.

- Remove heat shield - C -.

- Remove right heat shield -D- by removing bolts - A - from transmission.

Left transmission support

- Remove bolts - B -.

- Remove heat shield - C -.

• The left heat shield is not installed on 4 cylinder gasoline engines.

- Remove left heat shield -D- by removing bolts - A - from transmission.

Left and right transmission supports

- Unscrew nuts - A - on subframe.

- Remove transmission supports -E-.

• Items - C - and - B - are not installed on vehicles with hydraulic transmission bearing H, because bolt G is threaded directly into the transmission bearing.

Installing

Installation is the reverse of removal.

Tightening specifications for left and right transmission supports

Tightening specifications for left transmission support

Tightening specifications for right transmission support