01VA Transmission

ATF Lines and Cooler, Cleaning

Special tools, testers and auxiliary items required

• Drip tray (VAG1306)

• Hose, approx. 18 mm

• Compressed air gun, standard

• Protective glasses

• Always blow compressed air through oil cooler and ATF lines (max. 10 mbar) before installing a replacement transmission.

• When installing ATF lines, insert into transmission or cooler by hand until impact first and then tighten bolts.

CAUTION!
Wear protective glasses.

- Place drip tray (VAG1306) underneath.

- Remove bolt - 2 -.





- Disconnect ATF lines from transmission.

- Slide a hose with approx. 18 mm diameter onto ATF line - A - and secure with hose clamp. Place the other end of the hose into an appropriate container.

- Blow through ATF line - B - with compressed air gun.

- Change hose from ATF line - A - to ATF line - B - and repeat procedure.

- Replace O-ring - 1 -.

- Coat O-ring with ATF.

- Insert ATF lines completely into transmission by hand until stop.

- Re-secure ATF lines.

- Then check ATF level and top off. Refer to => [ ATF Level, Checking ] .