01V,01VA Transmission

Selector Lever Cable, Checking and Adjusting

Special tools, testers and auxiliary items required

• Socket and Key (T40031)

Procedure

- Remove cover for shift mechanism, refer to => [ Shift Mechanism Cover ] Shift Mechanism Cover.

- Place selector lever in position "S".

- Loosen rear clamping screw on selector lever cable through the hole in shift mechanism approximately one turn using Socket and Key (T40031).





• Loosen clamping screw only 1 turn but do not remove it.

• Clamping screw is only accessible in selector lever position " S".

• The selector lever must remain in position "S" with clamping bolt loosened, otherwise the setting is not correct.

- Carefully move selector lever forwards and backwards slightly without shifting to a different selector lever position.

- Pull selector lever completely toward rear once more until it stops in position "S" and release selector lever.

• Do not touch selector lever during the adjustment.

- In this position, tighten the clamping screw with the Socket and Key (T40031).

- Install cover for shift mechanism. Refer to => [ Shift Mechanism Cover ] Shift Mechanism Cover.

- Check shift mechanism. Refer to => [ Selector Mechanism, Checking ] 01V,01VA Transmission.

• Using the vehicle diagnosis, testing and information system (VAS 5051B), in the display field - 3 - compare the position of the multi-function switch and the position on the selector lever in "OBD", vehicle system "02 - transmission electronics ", "measured values, display group 4".





If shift mechanism does not function properly after adjusting selector lever cable:

- Bring selector lever cable into basic setting. Refer to => [ Selector Lever Cable, Bringing into Basic Setting ] Selector Lever Cable, Bringing Into Basic Setting.

Tightening Specifications