Removal and Replacement

Fuel Injectors

Removing

- Remove engine cover (arrows).





- Disconnect electrical connectors to Camshaft Position (CMP) Sensor - 1 - and to fuel injectors - 2 -.





- Remove retaining bolts - 3 - of fuel rail.

- Pull fuel distributor rail together with injectors off intake manifold and place it on a clean cloth at back of engine compartment.

CAUTION!
The fuel system is pressurized! Before opening the system place a cloth around the connection point. Then release pressure by carefully loosening the connection.

- Pull off retainer and disconnect injector.

• Replacement of fuel rail involves disconnecting fuel hoses.

Installing

Install in reverse order, paying attention to the following:

• Replace the O-rings at all opened connections. (when replacing the front O-ring, ensure that the plastic cap is not removed from the injector head. The O-ring must be pulled off over the plastic cap).

• Moisten the O-rings with clean engine oil.

• Make sure that the injectors are installed in the correct positions.

• Check to make sure that the retainer clamps are properly seated.

• Position fuel rail with secured injectors on intake manifold and press evenly into place.

Tightening Specifications