Leak Detection Pump: Service and Repair

Leak Detection Pump

Removing

• All cable ties which are opened or cut open when removing, must be replaced in the same position when installing.

- Remove left rear wheel.

- Remove left rear wheel housing liner.

- Remove nuts - arrows -.





- Disengage diagnostic pump with bracket.

- Separate the electrical connector - 3 - with ignition switched off.

- Disconnect hose coupling - 4 - by pressing release button.

- Cut the cable ties - 1 - and disconnect the hose - 2 -.

Installing

Installation is in reverse order of removal, note the following:

• Secure all hose connections using hose clamps appropriate for the model type.

• During installation, the cable ties must be re-installed at the same location.

- Secure hose - 2 - to bracket of leak detection pump with cable tie - 1 -.

Tightening Specifications