Cruise Control System, Coding II

Cruise Control System, Coding II

With ignition switched on and engine at standstill, the following operations can be performed using function "11 - Coding II ":

• Activating and deactivating cruise control system. Refer to => [ Cruise Control System, Activating/Deactivating ].

Cruise Control System, Activating/Deactivating

• For vehicles equipped with cruise control system, the cruise control system must be activated after replacing Engine Control Module (ECM).

• If cruise control system is activated in Engine Control Module (ECM) in a vehicle without the cruise control system, a DTC entry follows. In this case, the cruise control system function must be deactivated.

Work sequence

- Connect tester (VAS 5051) => [ VAS5051, Connecting and Selecting Functions ] VAS 5051, Connecting and Selecting Functions and select vehicle system "01 - Engine electronics". Ignition must be switched on for this.

Display on (VAS 5051):





- In selection - 1 -, select diagnostic function " 11 - Coding II".

Display on (VAS 5051):





1 - Enter code word

Activating cruise control system

- Select "11463" in button field - 2 - and press Q button to confirm input.

Deactivating cruise control system

- Select "16167" in button field - 2 - and press Q button to confirm input.

- End function "11 - Coding II" by pressing arrow -button.

Display on (VAS 5051):





- Select diagnostic function "08 - read measured value block " in selection - 1 -.

Display on (VAS 5051):





1 - Enter display group

- Select function "066" in button field - 2 - for " Display group number 066" and press Q button to confirm input.

Display on (VAS 5051):





- Check indication in display field - 2 -.





- Press arrow button to end function "08 - Read measuring value block".

- Select "06 - End Output"

- Switch ignition off.