Check DTC Memory (Scan Tool Function 02)

Check DTC Memory (Function 02)

NOTE: The DTC information on the display is only updated when the On Board Diagnostic (OBD) is started or when function 05 "Erase DTC memory" is selected. The display is not updated constantly.

- Switch on printer with the PRINT button (indicator lamp in button lights up).

Indicated on display

Rapid data transfer HELP
Select function XX

- Press buttons -0- and -2- to select "Check DTC Memory" function 02.

Indicated on display

Rapid data transfer Q
02 - Check DTC Memory

- Confirm entry with the -Q- button.

X DTCs recognized!

The number of stored DTCs appears in the display.

The stored DTCs are displayed and printed out one after the other.

- Check printout against Diagnostic Trouble Code (DTC) table and repair all malfunctions as necessary. Radio System, On-Board Diagnostic (OBD)

If "No DTC recognized" is displayed the program will return to the start point after pressing the -> button.

No DTC recognized! ->

Indicated on display

Rapid data transfer HELP
Select function XX

If something else is displayed:
See Scan tool operating instructions

- End Output (function 06)
- Switch off ignition and disconnect Data Link Connector (DLC).