Leak Detection Pump: Service and Repair

Removing
- Remove right-front wheel.
- Remove cover for vacuum lines.
- Remove right-rear wheelhousing liner.







- Disconnect hose connections -2- and -3- (connector coupling at metal sheet, engine side).
- Remove bolts (arrows).
- Remove Leak Detection Pump (LDP), disengage harness connector -1- with ignition off and disconnect.

Installing
Installation is the reverse of removal, noting the following:


NOTE: Secure all hose connections using hose clamps appropriate for the model type.


Tightening torque

Component Nm
Bracket for leak detection pump at wheelhousing 8